Res. Agr. Eng., 2003, 49(4):151-156 | DOI: 10.17221/4966-RAE

Testing stand for life tests of hydrostatic pumps with a polluted fluid

I. Petranský, M. Bolla
Slovak University of Agriculture, Nitra, Slovak Republic

Testing of the lifetime of hydrostatic transmissions can be done on special testing stands. Some testing stands use a pressure valve connected at the outlet of a pump. When using this design of stands, it is important to keep clear the operating fluid by filters and it is not possible to observe the influence of fluid pollution on the lifetime. The article presents a design of an electro-hydraulic testing stand with computer control system for accelerated lifetime tests of hydrostatic pumps under laboratory conditions when using a polluted operating fluid. A pump, which is mechanically connected with a hydrostatic motor, through a clutch, is an interface between the hydrostatic circuit of the tested pump and the hydrostatic circuit of the loading simulator. At lifetime testing, this interface makes it possible to use the polluted fluid in the hydraulic circuit of the tested pump, and thereby observe its influence. Instead of a polluted fluid, it is possible to use biodegradable oil and observe its influence on the lifetime of a pump. When using the same hydraulic fluid in both systems of the stand, it is possible to test two pumps at the same time.

Keywords: hydrostatic transmission; hydraulic oil PP 80; simulator of dynamic loading

Published: December 31, 2003  Show citation

ACS AIP APA ASA Harvard Chicago Chicago Notes IEEE ISO690 MLA NLM Turabian Vancouver
Petranský I, Bolla M. Testing stand for life tests of hydrostatic pumps with a polluted fluid. Res. Agr. Eng. 2003;49(4):151-156. doi: 10.17221/4966-RAE.
Share...
Download citation
  • BibTeX (.bib)
  • Bookends (.ris)
  • EasyBib (.ris)
  • EndNote (.enw)
  • EndNote 8 (.xml)
  • ISI WoS (.isi)
  • Medlars (.medlars)
  • Mendeley (.ris)
  • MODS (.xml)
  • Papers (.ris)
  • RefWorks (.txt)
  • RefManager (.ris)
  • RIS (.ris)
  • MS Word (.xml)
  • Zotero (.ris)
    • Open full article

    References

    1. DRABANT Š., 1984. Príspevok k problému optimalizácie dynamických charakteristík systémov. Acta Technol. Agric., Nitra, XXV: 14.
    2. DRABANT Š., 1977. Merací a riadiaci systém elektrohydraulického simulátora. In: Konf. Výmena skúseností pracovníkov katedier elektrotechniky, Košice: 7.
    3. TKÁČ Z., ŠKULEC R., 2002. Aplikácia bioodbúrateľného oleja v prevodovom a hydraulickom systéme traktora. Acta Mechanica Slovaca, 6 (2): 267-270.
    4. TKÁČ Z., ŠKULEC R., LENĎÁK P., VITÁZEK I., 2000. Sledovanie životnosti hydrogenerátora UN 10L.21 s biologicky odbúrateľnou kvapalinou. II. Medzinárodná vedecká konferencia mladých, Račková Dolina, SPU: 80-89. Go to original source...
    5. ŽIKLA A., DRABANT Š., 1978. Zisťovanie základných parametrov regulačnej hydrauliky v laboratórnych podmienkach. Zeměd. Techn., 33 (8): 10.

    This is an open access article distributed under the terms of the Creative Commons Attribution-NonCommercial 4.0 International (CC BY NC 4.0), which permits non-comercial use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.


    Return to the content