Res. Agr. Eng., 2006, 52(4):129-135 | DOI: 10.17221/4889-RAE
Load characteristic of tractor three-point hitch for their simulation in laboratory condition
- Faculty of Agricultural Engineering, Slovak University of Agriculture, Nitra, Slovak Republic
Presented paper is dealing with operation load of three-point hitch (TPH) of agriculture tractor in randomly changeable working conditions and their simulation in laboratory. The basic goal was to obtain experimental data, after which we can judge and analyze problematic of dynamic load of wheel tractor at plowing with orientation on TPH. Another goal was using obtained result from operating measures on their simulation in laboratory conditions by hydrostatic simulator. In presented paper is solved power analysis in each elements TPH of agricultural tractor ZTS 160 45URII A. The tractor during exploiting was in set with four-ploughshare carried and five-ploughshare semi-mounted plough. The measuring was realized for 3 varieties of set speed (gear ratio I/2, I/3, I/1), 3 depths of plowing (20, 25 and 27 cm) and 3 varieties of TPH - positional, mixed and draught control.
Keywords: load characteristic; three-point hitch of tractor; plow set
Published: December 31, 2006 Show citation
References
- Drabant Š. (1978): Výskum zaťaženia prevodového systému traktora pre simuláciu v laboratórnych podmienkach. [Kandidátska dizertačná práca.] VŠP, Nitra.
- Petranský I. (1989): Hydrostatické simulátory dynamického zaťažovania mobilných energetických prostriedkov a ich uzlov. [Doktorská dizertačná práca.] VŠP, Nitra.
- Tkáč Z., Škulec R. (2000): Aplikácia bioodbúrateľného oleja v prevodovom a hydraulickom systéme traktora. Acta Mechanica Slovaca, 6: 267-270.
- Tkáč Z., Škulec R., Lenďák P., Vitázek I. (2000): Sledovanie životnosti hydrogenerátora UN 10L.21 s biologicky odbúrateľnou kvapalinou. In: II. Medzinárodná vedecká konferencia mladých 2000. SPU, Nitra, 80-89.
Go to original source...
- Tkáč Z., Škulec R., Pokorný K. (2001): Elektroriadiaci systém traktora. In: Spoľahlivosť a kvalita strojov: 6. Medzinárodné vedecké sympózium. SPU, Nitra, 211-213.
This is an open access article distributed under the terms of the Creative Commons Attribution-NonCommercial 4.0 International (CC BY NC 4.0), which permits non-comercial use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.