Res. Agr. Eng., 2008, 54(2):91-96 | DOI: 10.17221/5/2008-RAE
Mechanical properties of cereal stem
- Slovak University of Agriculture in Nitra, Nitra, Slovak Republic
The paper deals with the measurement of the resonance frequencies of wheat stems with special respect to different wheat varieties. For the measurement, the dynamical method of the transverse frequency was used. Formulas were derived for the calculation of the bending toughness of stems. The t-test was used for the evaluation of the strength coefficient in bending for the samples of stems of different wheat varieties. The results can be used for the evaluation of the wheat resistance to lodging.
Keywords: wheat stems; resonance frequency; strength coefficient in bending; modulus of elasticity; mechanical properties of stem
Published: June 30, 2008 Show citation
References
- Dunca J. (2004): Využitie t-testu pri vyhodnotení pevnostných vlastností stebiel pšenice. In: Zborník z 11. odborného seminára, Piešťany, VÚRV, 104-105.
- Dunca J. (2005): Vyžitie niektorých matematických metód pri štúdiu prižných vlastností biologických materiálov. In: Zborník z medzinárodnej vedecko-odbornej konferencie XVIII.DIDMATTECH 2005, September 13-14, 2005, Prešov, 447-451.
Go to original source...
- Nepraš I. (1986): Meranie a kontrola v elektrotechnológii I. SVŠT, Bratislava.
- Plander I., Tomaš J. (1968): Dynamické vlastnosti viskoelastických materiálov a ich meranie. SAV, Bratislava.
- Pruckovova M.G., Uchanovova O. (1976): Nové odrody ozimnej pšenice. Príroda, Bratislava.
- Smirnov V.I. (1956): Kurz vyššej matematiky. Štátne vydavateľstvo technicko-teoretickej literatúry, Moskva.
This is an open access article distributed under the terms of the Creative Commons Attribution-NonCommercial 4.0 International (CC BY NC 4.0), which permits non-comercial use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.