Res. Agr. Eng., 2015, 61(1):47-53 | DOI: 10.17221/79/2012-RAE
Geometric performance parameters of three-point hitch linkage system of a 2WD Indian tractorOriginal Paper
- Department of Agricultural Engineering, Triguna Sen School of Technology, Assam University, Silchar, Assam, India
Geometric performance parameters of three-point hitch system of a most sold model of a 2-wheel drive Indian tractor were determined by generating the path of upper and lower hitch points by kinematic linkage analysis. At various locations of pivot point of upper link and adjustments in the length of lift rods, hitch linkage system of the tractor fulfilled all the requirements specified by the standards for category-I and II hitches. An insight into the kinematic linkage analysis revealed that the hitch linkage of the selected tractor is the most suitable for operations with soil working implements. Attachment of upper link to the topmost pivot point reduced the change in orientation of implement during lifting and ensured better weight transfer from implement to the rear axle of tractor. The kinematic linkage analysis has the potential to identify the best settings of the hitch linkage system for the effective utilization of tractor power during various farm operations.
Keywords: kinematic linkage analysis; Newton-Raphson solution; virtual hitch point; vertical convergence distance; mechanical advantage
Published: March 31, 2015 Show citation
References
- Kumar G.V.P. (2012): Development of a computer program for the path generation of tractor hitch points. Biosystems Engineering, 113: 272-283.
Go to original source... - Nastasoiu M., Vasilache L., Ispas N., Soica A., Nastasoiu S. (2010): Researches on the dimensional synthesis of the 3-point hitch couplers used at agricultural tractors. In: 11th International Congress on Automotive and Transport Engineering, Brasov, Transylvania University.
- Norton R.L. (1999): Design of Machinery, 2nd Ed. New York, McGraw-Hill.
- Pennock G.R. (2010): Henry George (Harry) Ferguson (1884-1960). In: Ceccarelli M. (ed.): Distinguished Figures in Mechanism and Machine Science. New York, Springer: 65-94. Go to original source...
- Vasilache L., Nastasoiu M., Nastasoiu S., Ispas N., Simeon C. (2010): Researches on the mathematical modeling of the kinematics of 3-point hitch couplers used at agricultural tractors. In: 11th International Congress on Automotive and Transport Engineering, Brasov, Romania, Transylvania University.
- Ambike S.S., Schmiedeler J.P. (2007): Application of geometric constraint programming to the kinematic design of 3-point hitches. Applied Engineering in Agriculture, 23: 13-21. Go to original source...
This is an open access article distributed under the terms of the Creative Commons Attribution-NonCommercial 4.0 International (CC BY NC 4.0), which permits non-comercial use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.